5
1
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
HOOK SCAN
When the Hook Scan function is preprogrammed, push this
key to temporarily disable the function. Push this key again to
enable the function.
USER SET MODE
Hold down for 1 second to enter the User Set mode. ➥
•WhileintheUserSetmode,pushthiskeytoselectanitem*,and
change the value or setting using [CH Up] or [CH Down].
* Selectable items may differ, depending on the preprogram-
ming.
Hold down this key for 1 second again to exit the User Set ➥
mode.
EXT. CH SEL MODE
Push to turn the Ext. CH Select function ON or OFF.
When the function is turned ON, memory channels can be
selected with only an external input.
When the function is turned OFF, memory channels can be
selected by pushing [CH Up] or [CH Down], and cannot be
externally controlled.
•This function is usable when an external unit, suchas a dimmer
control is connected to the transceiver with an optional OPC-1939
or OPC-2078 cable (p. 12).
•Askyourdealerformoredetailsonexternalinputoperation.
ANNOUNCE
Push to turn the Channel Announce function ON or OFF.
When this function is turned ON, the transceiver announces
the channel number when it is selected.
RESET
Push to return to the normal operating mode. ➥
While in the audible mode, push to return to the inaudible ➥
mode.
NOTE: See the operating guide for the [Reset] key opera-
tions in the digital mode.
GPS DISPLAY
Push to switch the display mode between stand-by and GPS
position data.
SHIFT
Push to switch the Normal mode key functions and the Shift
mode key functions.
•WhentheShiftmodeisselected,thedisplaybrieyshows“SHIFT
ON.”WhentheNormalmodeisselected,thedisplaybrieyshows
“SHIFT OFF.”
To Next Page
Loading...
Need help?
General
