6
2
BASIC OPERATION
Turning ON the power
■
Push q [ ] to turn ON the power.
If the transceiver is programmed for a start up password, w
input the digit codes that were set by your dealer.
•Thekeysshownbelowcanbeusedforpasswordinput:
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
If the “PASSWORD” indication does not clear after input- e
ting 6 digits, the input code number may be incorrect. Turn
OFF the power and re-enter your password.
Channel selection
■
There are several ways to select channels, and they may dif-
fer, depending on your system set up.
NON-ZONE TYPE:
Toselectthedesiredoperatingchannel:
Push [CH Up] or [CH Down]. ➥
Push one of [MR-CH 1] to [MR-CH 4]. ➥
ZONE TYPE:
Toselectthedesiredoperatingchannel:
Push [Zone], then push [CH Up] or [CH Down]. ➥
VOTING OPERATION:
The transceiver automatically starts scanning when a zone,
specified for the voting operation, is selected.
The voting scan detects the S-meter of the repeater and au-
tomatically selects the strongest station.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.
To Next Page
Loading...
Need help?
General
