Icom IC-F52D - Pairing with a Headset or a Data Device

11
Bluetooth
®
OPERATION
11-4
Step 1: Enter the Pairing mode (Device)
L See the Bluetooth device’s instruction manual for
details�
Step 2: Turn ON the Bluetooth function
(Transceiver)
L See page 11-3 for details�
Step 3: Search for the device (Transceiver)
1� Push [Menu] to display the “Menu” screen�
2� Push [P2 (Up)] or [P1 (Down)] to select
“Bluetooth,” then push [OK]�
Bluetooth ►
Vibration ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select
“Device List,” then push [OK]�
Bluetooth info ►
Device List ►
Bluetooth
4� Push [P2 (Up)] or [P1 (Down)] to select “Find
Device,” then push [OK]�
Find Device
Device List
TIP: If the transceiver has been connected to
the Bluetooth device before, its name may be
displayed in this step� In that case, push
[P2 (Up)] or [P1 (Down)] to select it, then push
[OK] to connect�
5� Push [P2 (Up)] or [P1 (Down)] to select “Headset”
or “Data Device,” then push [OK] to start
searching�
Headset
Data Device
Find Device Type
Searching
• When pairable devices are found, their names are
displayed on the screen�
ICOM BT-002
PC1
Find Device Result
TIP: If the transceiver cannot nd any pairable
devices, the following screen is displayed� In that
case, do step 4 to search for a device again�
Headset
Data Device
Find Device Type
► Continued on the next page.
Pairing with a headset or a data device
Cancel