3
REMOTE CONTROL OPERATION
1
1-3 COMMAND TABLE
Default
During During
Function
Code
Normal mode
Phone Patch mode
SUB code
Transceiver
Phone
Transceiver
Phone
System Control Exit 0002 ✔✔ ✔
†
✔ —
Repeat Start 0003 ✔✔ —— —
Repeat Stop 0004 ✔✔ —— —
TX Start 0005 — ✔
‡
—
†
✔
‡
—
TX Stop 0006 — — —
†
✔ —
RF Power (Low) 0007 ✔✔ —— —
RF Power (High) 0008 ✔✔ —— —
RX Unit OFF 0009 — ✔ —— —
RX Unit ON 0010 — ✔ —— —
TX/RX Unit OFF 0011 — ✔ —— —
TX/RX Unit ON 0012 — ✔ —— —
Master Enable 0013 ✔✔ —— —
Slave Enable 0014 ✔✔ —— —
TEL Dial 0015 ✔ — ✔ — Max. 24 digits of telephone number
TEL Autodial 0016 ✔ — ✔ —2 digits Autodial channel number
Mch Select 0017 ✔✔ ——2 digits Memory channel number
CPU All Reset 0018 — ✔ —— —
†
: When the Phone Patch mode is activated from the
telephone, the repeater may recognize signals
from a transceiver as being a signal from the tele-
phone due to the sidetone function of the phone
line. This will depend on the telephone company
that provides local service.
‡
: “TX Start” is prohibited from the telephone line
when “Slave Enable” (the backup repeater) is
activated.
To Next Page
Loading...
Need help?
General
