How to unlock the channel on an Icom IC-M23 Transceiver?
If the displayed channel on your Icom Transceiver cannot be changed, the Lock function may be activated. To turn it OFF, hold down [ ] (Hi/Lo) for 1 second.
Why is there no sound from the Icom IC-M23 speaker?
If your Icom Transceiver has no sound coming from the speaker, ensure that the squelch level isn't too high by setting it to the threshold level. Also, check that the volume isn't too low and adjust it accordingly. If the speaker has been exposed to water, remove the water from the speaker grill.
How to fix an Icom IC-M23 Transceiver that does not turn ON?
If your Icom Transceiver won't turn on, it could be due to an exhausted battery. Recharge the battery pack to solve this. Another possible cause is that the battery pack is not correctly inserted; make sure it is properly inserted.
What to do if Icom Transceiver transmitting is impossible, or high power can not be selected?
If your Icom Transceiver is unable to transmit or you can't select high power, it might be because some channels are limited to low power or are receive-only. Try changing the channel. Also, check if the output power is set to low and push [Hi/Lo] to select high power. A discharged battery may also be the reason, so try to recharge the battery pack.
Why does the scan not start on my Icom IC-M23 Transceiver?
If the Icom Transceiver scan does not start, it may be because “TAG” channels are not programmed. Set desired channels as “TAG” channels.
How to enable beep sounds on an Icom IC-M23?
If there are no beep sounds on your Icom Transceiver, the Beep Tone function may be turned OFF. Turn ON the Beep Tone in the set mode.
General| Brand | Icom |
|---|---|
| Model | IC-M23 |
| Category | Transceiver |
| Language | English |
To Next Page
