Need help?Do you have a question about the Icom IC-M220 and is the answer not in the manual?
General| Brand | Icom |
|---|---|
| Model | IC-M220 |
| Category | Transceiver |
| Language | English |
Critical safety warnings for operating and handling the transceiver.
Details required information for ordering replacement parts.
Lists important notes before disassembling the transceiver.
Covers frequency, power, dimensions, and environmental details.
Details output power, modulation, deviation, and audio characteristics.
Outlines sensitivity, squelch, selectivity, and audio performance.
Lists frequency, channels, and satellite systems for GPS.
Covers both top and bottom views of the main unit board.
Covers both top and bottom views of the logic unit board.
Details the steps to detach the front panel from the transceiver case.
Outlines the procedure for removing the logic unit from the front panel.
Describes the process for detaching the main unit from the chassis.
Lists required equipment and connection diagrams for adjustments.
Details the jig cable setup and the software interface for adjustments.
Details procedures for adjusting radio frequencies.
Covers sensitivity, squelch, audio, and power adjustments for reception.
Describes the procedure for adjusting the bit error ratio.
Covers output power, power consumption, spurious emissions, deviation, and sensitivity.
Lists all replaceable parts for the main unit with part numbers and descriptions.
Lists all replaceable parts for the logic unit with part numbers and descriptions.
Lists all replaceable parts for the MIC-JACK unit with part numbers and descriptions.
Lists all replaceable parts for the GPS-ANT unit with part numbers and descriptions.
Lists mechanical components for the chassis unit.
Lists mechanical components for the mic-jack unit.
Lists mechanical components for the GPS-ANT unit.
Lists mechanical components for the main unit.
Lists optional accessories and kits.
Lists mechanical components for the front unit.
Lists mechanical components for the logic unit.
Shows the component layout for the top side of the main unit PCB.
Shows the component layout for the bottom side of the main unit PCB.
Displays the component layout for the top side of the logic unit PCB.
Shows the component layout for the bottom side of the logic unit PCB.
Displays the component layout for the top side of the mic-jack unit PCB.
Shows the component layout for the bottom side of the mic-jack unit PCB.
Shows the component layout for the top side of the GPS-ANT unit PCB.
Shows the component layout for the bottom side of the GPS-ANT unit PCB.
Illustrates the overall system architecture and signal flow.
Shows the voltage distribution and lines within the main unit.
Illustrates voltage distribution and lines within the logic unit.
Shows voltage distribution and lines for the mic-jack unit.
Illustrates voltage distribution and lines for the GPS-ANT unit.
To Next Page
