EasyManua.ls Logo

Icom IC-M220 - Specifications; General Specifications; Transmitter Specifications; Receiver Specifications

Icom IC-M220
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 1 SPECIFICATIONS
1-1
M General
• Frequency coverage: TX 156.025 ~ 157.425 MHz
RX 156.050 ~ 163.275 MHz
DSC receiver 156.525 MHz
• Type of emission: 16K0G3E, 16K0G2B
• Antenna impedance: 50 Ω (nominal)
• Operating temperature range: −20ºC ~ +60ºC (−4ºF ~ +140ºF)
• Power supply voltage: 13.8 V DC nominal (11.7~15.9 V DC) negative ground
• Current drain: Receiving Maximum 1.2 A (at maximum audio)
Transmitting Maximum 5.0 A (at 25 W)
• Dimensions :
156.5 (W)×66.5 (H)×110.1 (D) mm (6.2 (W)×2.6 (H)×4.3 (D) inches)
• Weight (approximate):
700 g (1 Ib 9 oz); including HM-237B
M Transsitter
• Output power: 25 W (High power)
1 W (Low power)
• Modulation: Analog Frequency modulation
DSC Frequency shift keying modulation
• Maximum frequency deviation: ±5 kHz
• Frequency tolerance: ±5 ppm
• Spurious emissions: Less than −60 dBc
Adjacent channel power: More than 65 dB
Audio harmonic distortion: Less than 10% (at 60% deviation)
• Residual modulation: More than 40 dB
Audio frequency response
:
+1 ~ −3 dB of 6 dB octave from 500 ~ 2500 Hz
• Input impedance (Microphone)
: 2 kΩ
M Receiver
• Sensitivity: Transceiver −13 dBμ typical (at 12 dB SINAD)
DSC receiver −5 dBμ emf typical (at 1% BER)
• Squelch sensitivity: Less than −10 dBμ
• Adjacent channel selectivity: Transceiver More than 68 dB
DSC receiver More than 68 dBμ emf (at 1% BER)
• Intermodulation: Transceiver More than 63 dB
DSC receiver More than 55 dBμ emf (at 1% BER)
• Hum and Noise: More than 40 dB
Audio frequency response
:
+1 ~ −3 dB of 6 dB octave from 500 ~ 2500 Hz
• Audio output power: 4.5 W typical (at 10% distortion into the 4 load)
• Output impedance (Speaker): 4 Ω
M GPS receiver (
for only IC-M220G)
• Receive frequency: 1575.42 MHz
• Number of receive channels: For acquisition Maximum 24 channels
For calculation Maximum 12 channels
• Differential satellite: WAAS, EGNOS, MSAS, GAGAN
• GLONASS receive frequency: 1602 MHz
Measurements made in accordance with TIA-603/EIA-603B (transceiver) and IEC 62238 (DSC receiver, GPS receiver).
All stated specications are typical and subject to change without notice or obligation.

Other manuals for Icom IC-M220

Related product manuals