Icom ic-m423g - Page 45

35
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Select a desired intership channel using Dial or [ e Y]/[Z],
then push [ENT].
 •Intershipchannelsarealreadypresetintothetransceiverinthe
recommended order.
About Manual Entry:
Enter a desired group ID in the following way:
•SelectadesirednumberusingDial,or[Ω]/[≈].
•Push[ENT]orDialtosetit.
•Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
•Therstdigitisspeciedas‘0,’andtheseconddigitisotherthan
‘0’ for a Group ID.
•Thersttwodigitsare‘0’foranyCoaststationID.
A confirmation screen r is displayed.
 •Conrmthecallcontents.
Push [CALL] to make a Group call. t
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechannel
becomes clear.
After the Group call has been transmitted, the following y
screen is displayed.
Announce the information using the microphone. u
After the announcement, push [EXIT] to return to the nor- i
mal operating mode.