Icom ic-m424g - Menu Screen: System Configuration; UTC Offset and Noise Cancel Settings

68
7
DSC OPERATION
After making the individual DSC call, the transponder will r
display “DSC Transmission COMPLETED.”
 •Push[CLEAR]toreturntothescreendisplayedbeforeyouen-
tered the voice channel selection screen in step w.
 •ThetransceiverstandsbyonChannel70untilanacknowledge-
ment is received.
Step 2: Transceiver’s operation
When the acknowledgement is received, alarm sounds. t
If the acknowledgement ‘Able to comply’ is received, ➥
push [ALARM OFF] to stop the alarm, and then select
the intership channel specified in step w.
  •Adifferentintershipchannelwillbeselectedifthestationyou
called cannot use the channel.
  •Toreply,push[PTT]andspeakatyournormalvoicelevel.
  •YoucanchecktheMMSIcodeorthename,ifentered,ofthe
AIS target on the display.
If the acknowledgement ‘Unable to comply’ is received, ➥
push [ALARM OFF] to stop the alarm, and then “INDI-
VIDUAL CALL FAILED” is displayed.
y
After the communication is finished, push [EXIT] to return
to the normal operating mode.
Transponder’s display Transceiver’s display
[DSC]
[CLEAR]
[Z]
[Y]
TRANSPONDER
‘Able to comply’ is received
‘Unable to comply’ is received
■ Making an Individual call using an AIS transponder (Continued)