Icom ic-m424g - Menu Screen: NMEA Output Settings; NMEA Data Output Configuration

70
8
OTHER FUNCTIONS
New2001
Using the ■ RX Speaker
The RX Speaker function enables you to hear the received
audio through a PA speaker.
Connect a PA speaker as described on page 82.
Push q
[RX ] to enter the RX Speaker mode.
 •TheRXSpeakervolumeleveladjustmentscreenisdisplayed.
Rotate Dial or push [ w Y]/[Z]/[Ω]/[≈] to adjust the RX Speak-
er volume level, and then push [ENT].
 •“RX ” is displayed.
e Push [RX ] to return to the normal operating mode.
 •“RX ” disappears.
To adjust the audio output level in the RX Speaker mode,
hold down
[RX ] for 1 second to display the RX Speaker
volume level adjustment screen, and then rotate Dial. After
adjusting, push [ENT] to set it.
Using the ■ PA (Public Address)
The transceiver has a PA function to make announcements
through a PA speaker.
Connect a PA speaker rated at
more than 10 W at 10% distor-
tion with a 4 ˘ load,
as described on page 82.
•TransmittingisdisabledwhileinthePAmode.
Push [PA] to enter the Public Address mode. q
Hold down [PTT] and speak at your normal voice level. w
 •Whileholdingdown[PTT],thescreenbelowisdisplayed.
 •RotateDialor push [Y]/[Z]/[Ω]/[≈] to adjust the PA volume lev-
el.
Push [EXIT] to return to normal operating screen. e
While in the PA mode, the transmit and receive functions
are disabled. When the transceiver is transmitting, the PA
function is disabled.