Icom ic-m424g - DSC Operation: Individual Calls; Making an Individual DSC Call

30
7
DSC OPERATION
Making DSC calls ■
To ensure correct operation of the DSC function, make
sure you correctly set the CH70 SQL LEVEL. (p. 65)
D Making an individual call
The Individual call function allows you to make a DSC call to
only a specific station.
Enter “INDIVIDUAL CALL” in the DSC CALLS menu. q
MENU ➪ DSC Calls ➪ Individual Call
(Push [MENU].) (Rotate Dial, then push [ENT].)
Select a desired preset individual address, or “Manual In- w
put,” using Dial or [Y]/[Z], then push Dial or [ENT].
 •TheIDcodefortheIndividualcallcanbeenteredrst.(p.22)
 •When“ManualInput”isselected,enteradesired9digitMMSIID
code for the individual you wish to call.
 •Push[EXIT]toreturntothenormaloperatingmode.
 •Push[BACK]toreturntothepreviousscreen.
About Manual Entry:
Enter a desired individual ID in the following way:
•SelectadesirednumberusingDial,or[Ω]/[≈].
•Push[ENT]orDialtosetit.
•Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
•Therstdigitisspeciedas‘0’foraGroupID.Ifa9digitGroupID
is entered, an error beep sounds when pushing [ENT] or dial.
•Thersttwodigitsare‘0’foranycoaststationID.
NOTE: When a coast station is selected in step w, the
voice channel is automatically specified by the coast sta-
tion. Therefore, skip step e and go directly to step r.
+ Continued on the next page.