Need help?Do you have a question about the Icom IC-PW1 and is the answer not in the manual?
Covers frequency range, duty cycle, connectors, power, dimensions, and weight.
Details output power, driving power, and spurious emissions.
Specifies output matching range, tuning accuracy, input power, and insertion loss.
Explains exciter input, power splitter, amplifier, combiner, and filter circuits.
Details matching, detector, and motor control circuits for the tuner.
Covers general protection, ALC, and driving power detection circuits.
Describes the heatsink temperature detection and control mechanism.
Explains input power level detection for frequency band selection.
Lists various voltage lines and their descriptions within the unit.
Details pin assignments for expander ICs and shift registers.
Lists required test equipment and connection setup for adjustments.
Outlines procedures for adjusting idling current and meter maximum points.
Details adjustments for SWR detector, tuner basis voltage, and power settings.
Lists transistors and FETs with their symbols and inside views.
Lists diodes with their symbols and inside views.
Shows the layout and connections for the ANT-SW board.
Displays the layout and connections for the C-NET board.
Shows the layout and connections for the L-NET board.
Displays the layout and connections for the H-NET board.
Shows the layout and connections for the SPLITR unit.
Displays the layout and connections for the PA unit.
Shows the layout and connections for the MAIN unit.
Overall wiring diagram connecting various units and signals.
Detailed circuit diagram for splitter, PA, and combiner units.
Circuit diagram for the filter unit, showing band-specific filters.
Circuit diagram detailing the power amplifier units.
Circuit diagram for the front unit, including controls and indicators.
Circuit diagram for the main unit, showing complex control and processing logic.
Circuit diagram for the tuner unit, including antenna switching and tuning control.
To Next Page
General
