26
6
MEMORY PROGRAMMING
D Memory/call ➾ call/memory
q Select the memory (call) channel to be transferred:
Push [C•
MR
] ([
B•
CALL
]) to select the memory (call) mode.
Push [Y]/[Z] to select the memory channel.
• When [VOL] is assigned as “dial,” rotate [VOL] to select the mem-
ory channel. (p. 50)
w Push [C•
MR
] momentarily after pushing [A•
FUNC
].
• “--” and “
X
” flashes.
e Push [Y]/[Z] to select the target memory.
• When “dial” is assigned [VOL], rotate [VOL] to select the memory
channel. (p. 50)
r Push [C•
MR
] for 1 sec after pushing [A•
FUNC
].
• Memory mode is selected and the contents are transferred to
the target memory.
D Clearing a memory
q Push [C•
MR
] after pushing [A•
FUNC
] to enter the memory trans-
fer mode.
•“
X
” and a memory channel number flash.
w Push [Y]/[Z] to select the memory channel to be cleared.
• When [VOL] is assigned as “dial,” rotate [VOL] to select the mem-
ory channel. (p. 50)
• The call channel cannot be cleared.
e Push [C•
MR
] after pushing [A•
FUNC
] momentarily, then push
[C•
MR
] for 1 sec after pushing [A•
FUNC
] again.
• Perform this operation within 1.5 sec, otherwise the memory clear-
ing is cancelled and the transceiver returns to the memory mode.
• The contents of the selected memory are cleared.
r Push [D•
CLR
] to return to regular operation.
To Next Page
Loading...
