28
7
DTMF MEMORY
■ Transmitting a DTMF code
D Using a DTMF memory channel
q Push [0•
DTMF
-
M
] after pushing [A•
FUNC
] to enter the DTMF mem-
ory.
w Rotate [VOL] to select the desired channel.
e Push [SQL] or [PTT] to exit the DTMF memory mode.
r While pushing [PTT], push [SQL] to transmit the selected DTMF
memory.
• After the DTMF code is transmitted, the transceiver returns to re-
ceive automatically.
D Manual DTMF code transmission
While pushing [PTT], push digit keys, A–F to transmit a DTMF
code manually.
■ DTMF
transmission speed
When slow DTMF transmission speeds are required with DTMF
memory transmission (as for some repeaters), the transceiver’s rate
of DTMF transmission can be adjusted.
q While pushing [Y] and [Z], turn the power
on to enter
INITIAL SET MODE
.
w Push [Y]/[Z] several times until “dtd” ap-
pears.
e Rotate [VOL] to select the desired DTMF
transmission speed.
• Four speeds are available: “1” (100 msec.
intervals) is the fastest; “5” (500 msec. intervals) is the slowest.
r Push [#•
ENT
] to exit
INITIAL SET MODE
.
USING
INITIAL SET MODE
To Next Page
Loading...
