33
8
SCAN OPERATION
■ Scan resume condition
When a signal is received during
scanning, the scan resume condition
determines what action the transceiver
takes. The transceiver has 2 scan
resume conditions available as
illustrated at right. Use
SET MODE
to
select the one which best suits your
needs.
q Push [8•
SET
] after pushing [A•
FUNC
] to enter
SET MODE
.
w Push [Y]/[Z] several times until “SCP” or “SCt” appears.
e Rotate [VOL] to select the desired scan resume condition.
•
Pause scan:
When receiving a signal, scan
pauses on the signal until it disappears. Re-
sumes 2 sec. after the signal disappears.
Timer scan:
When receiving a signal, scan
pauses on the signal for 5 sec., 10 sec. or
15 sec., then resumes.
r Push [#•
ENT
] to set and exit
SET MODE
.
USING
SET MODE
Pause
scan
Receiving
a signal
Timer
scan
5, 10 or 15 sec.
2 sec.
MR
F
TX
MR
F
TX
Timer scan
Pause scan
To Next Page
Loading...
