Icom IP100H - What You will Need; Customers Current IP Settings

To Next Page

To Previous Page

Icom America, Inc.

12421 Willows Road NE

Kirkland, WA 98034

What You Will Need

• 1 IP1000C controller box

• Several IP100H radios

• Access point(s) – Either customer’s existing points or supplied by your Icom Dealer

(Linksys access point used in this guide)

• CS-IP100H cloning software, OPC-478UC (USB only) and the OPC2144 adapter

• Computer with IP100H software and USB drivers installed

• One CAT-5 LAN cable for programming the IP1000C controller and access point (if

required)

Customer’s Current IP Settings

In this example, we assume the following WLAN Network settings are programmed into the

customer’s WLAN Controller/Router prior to setting up the Icom IP Advanced Radio System.

• DHCP Server Enabled. Customer’s WLAN controller will assign all IP addresses to all the

Devices on that WLAN network.

Other manuals for Icom IP100H