©2014 Icom America Inc. Page 10
Icom America, Inc.
12421 Willows Road NE
Kirkland, WA 98034
2. Create Group 1 with 2 IP radios (as an example) as follows.
In our example, Group 1 will only have Unit ID 0001 and 0002 part of its Group. When making a
Group call – anther Unit ID, such as 0003, wouldn’t hear the call because it’s not part of that
Group.
3. Verify List of Destination Setting Entries (Group Call) shows Group 1.
Creating a Radio ID List in the IP1000C Web Interface
ID List Information
This ID list will be downloaded into the Radio over the WLAN network on initial Power up.
Note: You will need to enter in all the desired Group ID’s and Unit ID’s information here in the
order that you want it to appear on the Radio Display.
1. Click Common Setting tab and then ID List.
1. Verify that the ID List Common Settings Number is set to “1”. This represents an ID
profile number.
To Next Page
Loading...
