ICON V1-M - Launch Workflow

22
Launching the V1-M, iMAP and DAW/s
As we know, in order to use the V1-M to the fullest extent we must follow these
steps;
Note:
Please wait a few moments between each step, to ensure each is fully loaded.
The reason for the order of this process is because, as you can see from the diagram
below, the iMAP must occupy MIDI port 4 in order to communicate e󰀨ectively.
Unfortunately, some DAWs will automatically try to occupy that port when launched
and this will prevent the iMAP from functioning properly. The iMAP, therefore, needs
to be turned on rst to make sure it occupies that MIDI port.
Equally, to e󰀨ectively ‘link’ with any V1-X extenders you may be using, the iMAP
must be running in the background and should be turned on rst, before the
controllers and DAW/s.
Note:
MIDl port 4 is used by the iCON Pro Audio software, iMAP
TM
, to change the
three DAWs you use, to update rmware and to program the 16 panel touchscreen
with the functions of your choice. You cannot use this port to connect your device.
Step 1: Open the iMap
Step 2: Switch on the controller
Step 3: Launch the DAW/s you intend to use
V1-M V1.01
(V1-M V1.01)
(V1-M V1.01)
(V1-M V1.01)
Remember
iMAP
Controller
DAW
Every time you launch the V1-M