Appendix B: MiniOS7 utility
ET-7000 AIO User Manual, Apr. 2009, V1.04, EMH-011-104----------116
Step 3: After a connection between the ET-7000 and PC has been successfully
established, the following screen will be displayed. (The total files on the selected
ET-7000 shows on the file list of right hand window)
Step 4: Right Click the file list on the right hand window and then click Quit Firmware
item from TCP/IP mode to UDP mode.
Notes:
z The default firmware of ET-7000 series module is TCP/IP mode that uses the
TCP/IP protocol for communication. The Modbus/TCP protocol or Web
communication are constructed on this communication layer.
z The UDP mode is used to update the firmware and MiniOS7 image.
To Next Page
Loading...
