Cha
ter 1 Introduction
ET-7000 AIO User Manual, Apr. 2009, V1.04, EMH-011-104----------32
1.5.3. Ethernet cable wiring
Connecting the ET-7000 to Switch or Hub
Connecting the ET-7000 to a Host PC
As a result of the automatic MDI / MDI-X crossover for plug-and-play on the ET-7000 RJ45
port, there is no need to a crossover cable to connect the ET-7000 to the Host PC, and
only a general straight-through cable is needed to make the connection. The straight-
through cable is shown as follows:
To Next Page
Loading...
