ICP DAS USA ET-7000 Series - Page 41


Chapter 1 Introduction
ET-7000 AIO User Manual, Apr. 2009, V1.04, EMH-011-104----------41
Table 1.8.2 Calibration resistors for the ET-7015:
Type code Zero Calibration Resistor Span Calibration Resistor
2B
0 Ohm
200 Ohm
20
0 Ohm
375 Ohm
2A 0 Ohm 3200 Ohm
Note:
1. Types 21 to 29, 2E, 2F, 80 81 and 83 use the same calibration parameters as type 20.
2. Type 2C and 82 uses the same calibration parameters as type 2B.
3. Type 2D uses the same calibration parameters as type 2A.
Table 1.8.3 RTD Input Type
Type Code RTD Input Type Temperature Range °C
20 Platinum 100, α= 0.00385 -100 ~ 100
21 Platinum 100, α= 0.00385 0 ~ 100
22 Platinum 100, α= 0.00385 0 ~ 200
23 Platinum 100, α= 0.00385 0 ~ 600
24 Platinum 100, α= 0.003916 -100 ~ 100
25 Platinum 100, α= 0.003916 0 ~ 100
26 Platinum 100, α= 0.003916 0 ~ 200
27 Platinum 100, α= 0.003916 0 ~ 600
28 Nickel 120 -80 ~ 100
29 Nickel 120 0 ~ 100
2A Platinum 1000, α= 0.00385 -200 ~ 600
2B Cu 100 @ 0°C,α= 0.00421 -20 ~ 150
2C Cu 100 @ 25°C,α= 0.00427 0 ~ 200
2D Cu 1000 @ 0°C,α= 0.00421 -20 ~ 150
2E Platinum 100, α= 0.00385 -200 ~ 200
2F Platinum 100, α= 0.003916 -200 ~ 200
80 Platinum 100, α= 0.00385 -200 ~ 600
81 Platinum 100, α= 0.003916 -200 ~ 600
82 Cu 50 @ 0°C -50 ~ 150
83 Nickel 100 -60 ~ 180