114 115
TX HEAVYTX HEAVY
3.5 CLEANING INSTRUCTIONS
The remote control should only be cleaned with a damp cloth and without chemicals.
3.6 CARE AND MAINTENANCE
We recommend that you clean the remote control weekly as described
in the previous section (damp cloth, no chemicals). If the remote control
is used in a very dirty, e.g. dusty, environment, we recommend that you
clean it every day to avoid possible resulting damage.
When changing the batteries, please check the contacts for corrosion
and clean with a small brush if necessary. You should ensure that
the surface of the contacts is not damaged.
3.7 TRANSMITTER FAULT FINDING
If the transmitter only works over short distances, please proceed as follows:
I. Ensure that the distance between the transmitter
and receiver is not greater than 50 metres.
II. Ensure that there are as few objects as possible, particularly
metallic objects, between the transmitter and the receiver.
III. If you are surrounded by a metallic grating or another
heavy metallic structure, please leave these surroundings.
IV. Check if there are transmission masts in the immediate vicinity,
which could lead to faults, and if necessary leave this area.
V. Check if there are cables in the immediate vicinity carrying
high voltage or current and leave these surroundings if necessary.
If the transmitter still does not work correctly after carrying out these steps,
please contact your supplier.
ENENEN
POWER LED lights up
after switching on
When a button is
pressed the POWER
LED flashes quickly
BATTERY LED is flashing
The transmitter is defective.
Please contact the supplier.
– Switch off transmitter
– Change the batteries
– Power switch on
Does the transmitter work now?
– Switch off transmitter
– Wait for 10 seconds
– Power switch on
Does the transmitter work now?
NO YES
YES NO
NO
NONO
To Next Page
Loading...
Need help?
General
