iDRY Series Heatless Regenerated Dryers: IOM10003-C (Rev. A) 18
7.6 Service Reset Button
The service indicator LED can be reset after maintenance or service is performed on the dryer by pressing
the RESET button located in the lower right corner of the controller.
After 360-days of the service indicator LED will flash amber indicating that service is due, and after 400-
days the LED will flash red indicating that service is overdue.
7.7 Power Requirements
The controller operates on 100-120VAC / 50-60Hz. The units are shipped with an installed standard US 120 volt cord for
convenience. Before starting up the machine it is necessary to have a qualified electrician review the electrical
requirements schematic and install to the National Electric Code. Please refer to Section 12.
The optional iMAT on the pre-filter at the dryer inlet is supplied according to the power voltage indicated
in the order; verify its compatibility with the information given on the type plate.
To Next Page
Loading...
