iDRY Series Heatless Regenerated Dryers: IOM10003-C (Rev. A) 3
1. SAFETY AND SYSTEM PRECAUTIONS
1.1 Definition of the Safety Symbols
Before attempting any
service, please read
the manual
Possibility of
electrocution
Water cannot be used
to extinguish fire
Do not operate if parts
are missing or have been
tampered with
Machine level noise
may exceed 85 dBA
Personal
protection
required
All work to be
performed by qualified
personnel only
Operations that can be
performed by qualified
operators
1
Compressed air inlet connection
Compressed air outlet connection
Connection point for condensate drain
1 Only experienced and trained personnel familiar with all of the relevant laws, rules and regulations, capable to perform the needed activities and to
identify and avoid possible dangerous situations while handling, installing, using and servicing the machine.
1.2 Operational Warnings
WARNING: VESSELS UNDER PRESSURE
In most countries, states, cities and/or local municipalities the installation, operation and maintenance of
devices where pressure vessels are in use are subject to local boiler and pressure vessel regulations.
The end user is responsible for following all of the relevant laws, rules and regulations and ensuring that only
experienced and trained personnel install and/or operate the dryer.
In most countries, states, cities and/or local municipalities the installation may only be carried out by a
licensed installation company. Inspections must be carried out by a qualified and licensed third-party firm in
accordance with all applicable laws, rules and regulations for the region where the dryer is installed.
The pressure vessels used in this device are built according to the American Society of Mechanical Engineers
(ASME) standard Section 8, Division 1.
Compressed Air Warning:
Compressed air is a highly dangerous energy source.
Never work on the dryer while components are under pressure.
Never point the compressed air stream or the condensate drain outlet towards anybody.
The end user is responsible for the installation of the dryer as laid out in this manual. If proper commissioning steps are
not followed, the warranty will be void and dangerous situations involving injury or death and/or damages to the
machine could occur.
Only qualified personnel can use and service electrically powered devices. Before attempting any maintenance:
Ensure that no part of the machine is powered and is locked out of the electrical mains by following proper
“Lock-out, Tag-out” procedures and requirements.
Ensure that no part of the dryer is under pressure by isolating the dryer from the compressed air system.
Any change to the machine or to the standard operating parameters (see page 5), if not previously verified and
authorized by the manufacturer, in addition to creating a potentially dangerous situation, will void the warranty.
Don’t use water to extinguish fire on the dryer or in the surrounding area.
To Next Page
Loading...
Need help?
General
