NaviTEK NT 151844 Iss 4
User Guide Page 19
o Length - Number of bytes in the Ping packet
• TRoute Setup
o TRoute - Include or omit the Trace Route test from the NET TEST
o Max Hops - The number of hops that can be detected before the test
fails to reach the destination target
o Timeout - the timeout before the test fails to reach the destination
target
o Name Lookup - When ticked, the name of each hop is included in the
test result. Note that selecting this option causes the test time to be
longer
• IPv4 Netscan setup
o Netscan - Disable Netscan from inclusion in the NET TEST or select
Local or Custom network
o IP Addr - Set Custom network sub-net
o Scan range - Select a small scan range (Class C) for fast test time or
a larger scan range (Class B) for a wider search
o Subnet Mask - Select the subnet required
Set the details of the Power over Ethernet test:
• Type
o PoE - Applies a load to draw current up to the maximum allowed for
PoE
o PoE+ - Applies a load to draw current up to the maximum allowed
for PoE+
o None - PoE test disabled
• Min PoE power (W)
o Enter the minimum power in watts for the PoE test to pass
• Min PoE+ power (W)
o Enter the minimum power in watts for the PoE+ test to pass
Set the details of the Ping 4 test
Set the details of the Ping 6 test
Set the parameters for the Ethernet Loop
Set up a list of targets to be used in the Ping and TRoute tests using IPv4 addresses
or URLs
Set up a list of targets to be used in the Ping and TRoute tests, using IPv6 addresses
or URLs
Select RJ45 to set the parameters for the RJ45 copper port including Auto
Negotiation, Speed, Mode, Min Rx frame size, MDI and MAC address.
Select VLAN to set the VLAN ID and Priority of the tester if required
Select OPTICAL to view information about the SFP fitted. The SFP types that follow
are supported. The use of other SFP types is possible but correct operation is not
guaranteed.
To Next Page
Loading...
