This installation instruction covers two main products types: wall mount and rim mount.
Products within this range can be installed either on a panel/wall over a bath or on the rim
of a bath.
• Panel/wall mount products are: A5634AA & A5639AA.
• Rim mount products: A5635AA, A5636AA and A5638AA.
Panel/wall mount products are supplied with a fast-x wall bracket kit, rim mount products are supplied
with a pair of bath legs with xings.
Both product types have dual control handles with integral diverter. The temperature and the ow rate of
the water can be adjusted using the two control handles on the mixer.
The diverter knob is located on the right hand side of the spout and permits mixed water to be directed
from the default bath ll to the shower outlet. A exible shower hose can be connected to the shower
outlet on the underside of the mixer.
Note: Idealrain S3 Shower Kit is only supplied with product A5636AA. For the other products the installer
should purchase a suitable shower kit.
4 Pre-installation notes
8
Water supply pipes
Water supply pipes can be from any direction. Where supplies are provided from above, this normally
permits better drain down of pipe-work. Pipe-work should be secured to the wall or panel using suitable
xing clips.
DO NOT apply heat near this product. Heat generated
by soldering could damage plastic parts and seals
Suitable pipe connectors
All the pipe connections needed for the panel/wall mount products are supplied. For the rim mount
products, the installer will need a pair of tap connectors threaded G3/4” female.
Suitable pipe connectors can be obtained from all good plumbers merchants (not supplied).
IMPORTANT: Ensure that any old / existing thermostatic mixing valves (TMVs)
that may be tted in the supply pipes are removed
To Next Page
Loading...
Need help?
General
