Ideal Standard International NV
Corporate Village - Gent Building
Da Vincilaan 2
1935 Zaventem
Belgium
www.idealstandardinternational.com
1121 / A 868 898 40
Made in Germany
CUSTOMER CARE HELP LINE
0870 129 6085
CUSTOMER CARE FAX
01482 499611
E-MAIL
UKcustcare@idealstandard.com
Ideal Standard (UK) Ltd
Ideal Standard,
The Bathroom Works, National Avenue
Kingston-upon-Hull, HU 4HS, England
23 INLINE SERVICE VALVES
When cleaning chromed products use only a mild detergent, rinse & wipe dry with
a soft cloth. Ideally clean after each use to maintain appearance.
Never use abrasive, scouring powders or scrapers. Never use cleaning agents
containing alcohol, ammonia, hydrochloric acid, sulphuric acid, nitric acid,
phosphoric acid or organic solvents. Use of incorrect cleaning products / methods may result in chrome
damage which is not covered by the manufacturer’s guarantee.
24 CLEANING CHROME SURFACES
Inline service valves (not supplied with this product) MUST be tted to permit future maintenance of
the cartridges. They also facilitate the cold water isolation test.
These should be tted as close as is practicable to the water supply inlets of the thermostatic shower
valve. Service valves should be installed in an easily accessible location.
Basic valve with isolating
only feature is available un-
der spares code S9005AA.
15mm compression fittings
at both ends & plated nish.
E960086NU. Brass valve
with isolating & lter only
features. 15mm com-
pression fittings at both
ends. Supplied in pairs.
Spares code E960613NU contains
a pair of combined service valves.
Include a ow regulator, check valve,
strainer mesh (filter) & isolating
valve. The ow regulator and check
valve can be removed if not required.
Ideal Standard pursues a policy of continuing improvements
in design & performance of its products. This right is there-
fore reserved to vary specication without notice. Partial
or total reproduction or copying of this manual without our
permission is prohibited. Every eort has been made to en-
sure the accuracy of its contents. However, if you discover
any errors, please contact us. The manufacturer shall not be
held liable for consequences arising from use of the product.
The drawings & diagrams contained in this manual are to be
considered approximate & are provided for information only.
For more information about our products & spares
visit our website: www.idealstandard.co.uk
To Previous Page
Loading...
Need help?
General
