IDEAL EXALT Solo 199 User Manual

The installation must conform to the
requirements of the authority having
jurisdiction or, in the absence of such
requirements, to the National Fuel Gas
Code, ANSI Z223.1/ NFPA 54, and/or
Natural Gas and Propane Installation
Code, CAN/CSA B149.1.
NOTICE
VENT SUPPLEMENT
Exalt Solo 110-155-199 & Exalt Combi 155-199
223924 A01 - October 2019
2019-31
This document is intended to be used by a factory trained and qualified heating
contractor or service technician only. Read all Instructions within this document and
within the relevant Boiler Installation and Maintenance Manual before proceeding.
It is recommended to follow the procedures in the steps given. Skipping or missing
procedural steps could result in substantial property damage, serious injury, or death.
WARNING

IDEAL EXALT Solo 199 Specifications

General

Fuel Type	Natural Gas
Mounting	Wall Mounted
Boiler Type	Combi
ERP Rating	A
Efficiency	94%
Heating Flow Temperature	30°C - 80°C

Summary

Product and Safety Information

General Installation Warnings

Highlights critical warnings regarding installation procedures and potential hazards.

Carbon Monoxide Hazard Warning

Details severe risks associated with carbon monoxide and requires detector installation.

Chapter 1 - Pre-Installation Requirements

Vent/Combustion Air Piping and Materials

Specifies approved materials and methods for vent and combustion air piping installation.

Combustion Air Contamination

Warns about contaminants that can damage the unit and cause hazards.

Chapter 2 - Direct Vent Installation of Vent/Air Piping

Vertical Through Roof or Unused Chimney

Covers direct vent installation for vertical terminations through roofs or chimneys.

Determine Termination Location (Vertical)

Guides on selecting appropriate locations for vertical vent and combustion air terminations.

Horizontal Sidewall Termination

Covers direct vent installation for horizontal terminations through sidewalls.

Determine Termination Location (Sidewall)

Guides on selecting appropriate locations for sidewall vent and combustion air terminations.

Vertical Vent and Sidewall Combustion Air

Covers installations with vertical vent and sidewall combustion air configurations.

Determine Termination Location (Vertical/Sidewall)

Chapter 3 - Category IV (Indoor Air) Installation of Vent/Air Piping

Vertical Through Roof or Unused Chimney (Category IV)

Covers Category IV direct vent installation for vertical terminations through roofs or chimneys.

Determine Termination Location (Category IV Vertical)

Horizontal Sidewall (Category IV)

Covers Category IV direct vent installation for horizontal terminations through sidewalls.

Determine Termination Location (Category IV Sidewall)

Chapter 4 - Installation Requirements

Vent/Combustion Air Transitions

Connecting Piping to EXALT

Explains how to properly connect vent and combustion air piping to the EXALT appliance.

Carbon Monoxide Detector Installation

Recommends and details the installation of carbon monoxide detectors.