IDEAL Independent C24 - Fault Finding


FAULT FINDING
FAULT FINDING FAULT FINDING FAULT FINDING FAULT FINDING FAULT FINDING
Independent - Installation and Servicing
74 ALTERNATING ‘L’ AND ‘1’ - FLOW TEMPERATURE OVERHEAT LOCKOUT




















75 ALTERNATING ‘L’ AND ‘2’ - IGNITION LOCKOUT






















































* Note: due to the wave form of the rectied voltage, the reading will vary depending on the type of meter used to measure the
value. In general terms a reading greater than 150V indicates that the correct voltage is supplied to the gas valve.

Ω



RESET PROCEDURE
RESET PROCEDURE
205367-3.indd 51 13/12/2010 16:21:42