IDEC HR6S-AF - Page 25

Technical Data
HR9Z-B2192 8/2020 25
Wire Cross Sections, Stripping Lengths, and Tightening Torques
Characteristic Value
Stripping length for Push-in terminals 12 mm (0.47 in)
Stripping length for screw terminals 7 ... 8 mm (0.28 ... 0.31 in)
Wire cross section, single wire without wire ferrule
(1)
0.2 ... 2.5 mm
2
(24 ... 12 AWG)
Wire cross section, single wire with wire ferrule
0.25 ... 2.5 mm
2
(24 ... 12 AWG)
Wire cross section, two wires without wire ferrule
(1)
0.2 ... 1.5 mm
2
(24 ... 16 AWG)
Wire cross section, two wires with uninsulated wire
ferrule
0.25 ... 1 mm
2
(24 ... 18 AWG)
Wire cross section, two wires with insulated wire
ferrule
0.5 ... 1.5 mm
2
(20 ... 16 AWG)
Tightening torque for screw terminals 0.5 ... 0.6 N m (4.4 ... 5.3 lb in)
(1) Stranded or solid