IDEC HR6S-AF - Mechanical Installation

Installation
HR9Z-B2192 8/2020 49
Mechanical Installation
Mounting to DIN Rail
The device can be mounted to the following DIN rails as per IEC 60715:
 35 x 15 mm (1.38 x 0.59 in)
 35 x 7.5 mm (1.38 x 0.29 in)
Mounting procedure (left illustration)
Dismounting procedure (center illustration)
Step Action
1 Slightly tilt the device and hook it onto the DIN rail.
2 Push the lower part of the device towards the DIN rail.
3 Snap in the DIN rail clip.
Step Action
1 Unlock the DIN rail clip using a screwdriver.
2 Pull the lower part of the device away from the DIN rail and lift the device towards the top to
remove it from the DIN rail.
mm
in.
15
0.59
35
1 38
7.5
0.29
1
0.04
1
0.04