Configuration and Commissioning
HR9Z-B2192 8/2020 73
Configuration Procedure
Step Action
1 Verify that the device has been wired according to the safety-related function to be configured.
2 Remove power if the device is not powered off.
If an extension module HR6S-EP is connected, remove power from the extension module as
well.
3 Open the transparent cover of the device.
4 Set the application function selector to the required application function.
5 Set the start function selector to the required start function.
6 Commission the device according to the chapter Commissioning
(see page 74)
.
To Next Page
Loading...