IDEC MICROSmart FC6A-C24R1CE Ladder Programming Manual

FC6A S ERIES MICROS MART L ADDER P ROGRAMMING M ANUAL FC9Y-B1726 18-7
18: P ULSE O UTPUT I NSTRUCTIONS
Sample program
This section describes an example program that outputs 5,000 pulses (each at 200 Hz) and then 60,000 pulses (each at 500 Hz)
from output Q0
Settings
Function Device Address Setting Value Details
Output pulse frequency D0000 200 200 Hz
Pulse counting — 1 Enable pulse counting
Preset value D0002, D0003 5000 Preset value=5,000
M0000
SOTU
M0001
S
M0101
R
SOTU
M8120
M0101
I0000 M0101
REPD1 -
D0000
MOV(D) S1 -
500
REPD1 -
D0002
MOV(D) S1 -
60000
D1
M0100
S2
M0000
PULS
1
S1
D0000
M0001
When the PULS1 instruction input (I0) turns on, a 200 Hz frequency
pulse is output, and after 5,000 pulses, pulse output complete
(M0101) turns on and pulse output stops.
Then ladder (1) is executed, and after the frequency and preset
value are changed, a 500 Hz pulse is output, and after 60,000 pulses,
pulse output complete (M0101) turns on and pulse output stops.
Pulse output complete (M0101) turns off (pulse output not complete)
Turn on M0001 to output next pulse
60,000 is stored in the preset value
(D0002, D0003).
Store 500 (500 Hz) in frequency
(D0000, D0001)
Turn on initialization input (M0000)
Ladder (1)

IDEC MICROSmart FC6A-C24R1CE Specifications

General

Brand	IDEC
Model	MICROSmart FC6A-C24R1CE
Category	Computer Hardware
Language	English