IDENTEC SOLUTIONS i-MARK 2 - Introduction; Preparations; Scope of this Document; Responsibility

i-MARK 2 / i-MARK 3
USER MANUAL
VISIBILITY DELIVERED. PAGE 11 OF 55
2 INTRODUCTION
Compact Unit i-MARK 2
Central unit i-MARK 3
2.1 Preparations
This installation manual must be read carefully prior to starting the installation. The described
installation works assume that installation materials like cable, antenna and data tag holder etc are
available.
2.2 Scope of This Document
This document is the hardware description of both the i-MARK 2 and i-MARK3. This document is
intended only for mechanical and electrical installation of this central units. A general system
description, especially of the position marker technology can be found in the extra system description;
please see below.
2.3 Responsibility
IDENTEC SOLUTIONS is not responsible for any errors contained in this document.