IDENTEC SOLUTIONS i-MARK 2 - Page 4

i-MARK 2 / i-MARK 3
USER MANUAL
VISIBILITY DELIVERED. PAGE 4 OF 55
Important Note
To comply with FCC radio frequency exposure compliance requirements, this device must be installed
by an IDENTEC SOLUTIONS certified technician. When installing antennas, a 20 centimeter passing
distance must be maintained from any body part of the user, or nearby persons and the antenna.
The installer of this radio equipment must ensure that the antenna is located or pointed such that it
does not emit RF field in excess of Health Canada limits for the general population; consult Safety
Code 6, obtainable from Health Canada.
European Notification according R&TTE Directive
This equipment complies to Art. 6.4 of R&TTE Directive (1999/5/EC). It is tested for compliance with the
following standards:
EN 300 220-1 V1.3.1 (2000-09), EN 300 220-3 V1.3.1 (2000-09), ETSI EN 301 489 V1.4.1 (2002-08), ETSI
EN 301 489 V1.4.1 (2002-08)