Idex HURST eDRAULIC SC 258 E2 - Oil Change; Edraulic Combination Tools

26
Inspections to be carried out:
Visual Inspection
Combination tool
• Openingwidthofthebladearmsonthetips(seechapter"Technicaldata"),
• Generaltightness(leaks),
• Operabilityofthestargrip-checktheautomaticreturnintomiddlepositionafterrelease
(deadman’sfunction),
• Existenceandstabilityofhandle,
• Labelscompleteandlegible,
• Coversinperfectcondition,
• Checkthetorqueofthepivotbolt(fortorqueM
A,
see"TechnicalData").
• Bladearmsfreeofcracksandnicksordeformationsonthecuttingsurfaces,
• Cuttingsurfacestontopofeachotherwithoutmakingcontact,
• Theslidingplates,boltsandretainingringsofthebladearmsareinplaceandingood
condition,
• Illuminationofmainswitch,workareaandconnectionshaftfullyfunctional.
Battery and power supply
• Casingundamaged
• Electricalcontactsurfacescleanandundamaged
• Cableundamaged
• Battery(-ies)fullycharged(whenused)
• Chargingstatedisplayoflithium-ionbatteryorbatteriesfullyfunctional
• Thebatteryhasnotbeenexposedtowater,oilormoisture
• There are no signs that the battery has been damaged or that it is malfunctioning or
operating inconsistently with Akku Power GmbH Safety Instructions for eDRAULIC
batterieswhichareincludedwiththebatteries
8.2 eDRAULIC combination tools
8.1 Oil change
Under normal working conditions routine oil changes are not necessary with eDRAULIC
tools.
Theprerequisiteisthat:
• thetoolsarealwaysproperlyhandledandstowedaspertheapplicableoperatingmanual
• thetoolsaretestedonaregularbasisasperourinstructionsonpreventivemaintenance
(seechapter8)
• after10yearsservicelifeanoilchangeisrecommended
Regular tests, oil change and/or repairs must be carried out by repair and maintenance
personnelthatistrainedandauthorizedbythemanufacturer.