Idex HURST eDRAULIC SC 258 E2 - Preventive Service; Repairs

29
9.2 Preventive service
9.2.1 Care instructions
Theoutside of thedevice should becleaned with adamp cloth fromtime to time(not the
electrical contacts in the connection slot, on the battery and on the power supply
).In
addition,themetalsurfacesaretocoatedwithasuitablemediumtocounteractcorrosion(not
the electrical contacts in the connection slot, on the battery
andonthepowersupply).
(In case of doubt, contact your authorized HURST dealer or HURST directly!)
9.2.2 Function and load test
Ifthereisanydoubtregardingthesafetyorreliabilityofadevice,afunctionandstresstest
mustalsobeperformed.
HURSTo󰀨ersappropriatetestequipmentforthis.
9.3.1 Replacing the blade, protective cover and hand grip of the
combination tool SC 258 E2, SC 358 E2, SC 757 E2 and SC 757 E2
9.3 Repairs
Components to be
replaced
Required work steps
Protectivecover 1.,2.and7.
Pivotbolt 1.-4.and7.
Handle 1.-6.and7.
Blade 1.-5.and7.