Table of Contents
Section 1. Introduction
Description 1
Section 2. Installation
Host Connections 2
Section 3. Configuration
Default Settings 3
Configuration Setup Steps 4
General Selections 5
Change to Default Settings 6
Review Settings 6
Message Formatting Selections 8
Magnetic Track Selections 9
Section 4. Data Editing
Functions 12
Fields 13
Formulas 14
Setup Commands 15
Search Command 16
Send Command 19
Section 5. Operation
Operating Procedure 21
Section 6. Troubleshooting
General Procedures 22
Keyboard Interface Problems 23
Appendix A. Default Settings
Default Settings Table 24
Appendix B. Function Codes
Function Codes Table 25
Appendix C. Non-Printable ASCII Characters
ASCII Characters Table 26
Appendix D. Magnetic Stripe Standard Data Formats
ISO Credit Card 27
California Driver’s License 28
AAMVA Driver’s License 29
Appendix E. USB/Keyboard Interface
Installation 31
Operation 32
Agency Approved
Specifications for subpart B of part 15 of FCC rule for a Class A
computing device.
Limited Warranty
ID TECH warrants this product to be in good working order for a
period of one year from the date of purchase. If this product is not in
good working order as warranted above, or should this product fail to
be in good working order at any time during the warranty period, repair
or replacement shall be provided by ID TECH.
This warranty does not cover incidental or consequential damages
incurred by consumer misuse, or modification of said product. For
limited warranty service during the warranty period, please contact ID
TECH to obtain an RMA number and instructions for returning the
product.
©2004 ID Technologies, Inc. The information contained herein is
provided to the user as a convenience. While every effort has been
made to ensure accuracy, ID TECH is not responsible for damages
that might occur because of errors or omissions, including any loss of
profit or other commercial damage. The specifications described herein
were current at the time of publication, but are subject to change at
any time without prior notice.
ID TECH is a registered trademark of ID Technologies, Inc. MiniMag
and Value through Innovation are trademarks of ID Technologies, Inc.
To Next Page
Loading...
