IDTECH NEO2 - Page 124

114 Class Documentation
Parameters
serviceCode Service Code list. Each service code must be be 2 bytes
blockList Block list.
data Block to write. Must be 16 bytes.
statusFlag Status flag response as explained in FeliCA Lite-S User's Manual, Section 4.5
Returns
RETURN_CODE: Values can be parsed with errorCode.getErrorString()
13.7.2.69 - (RETURN_CODE) felica_writeWithMac: (int) blockNumber data:(NSData ∗) data
FeliCa Write with MAC Generation
Writes a block with MAC Generation. FeliCa Authentication must be performed first
NOTE: The reader must be in Pass Through Mode for FeliCa commands to work.
Parameters
blockNumber Number of block
data Block to write. Must be 16 bytes.
Returns
RETURN_CODE: Values can be parsed with errorCode.getErrorString()
13.7.2.70 - (RETURN_CODE) icc_exchangeAPDU: (NSData ∗) dataAPDU response:(APDUResponse ∗∗) response
Exchange APDU (unencrypted)
Sends an APDU packet to the ICC. If successful, response is returned in APDUResult class instance in response
parameter.
Parameters
dataAPDU APDU data packet
response Unencrypted/encrypted parsed APDU response
Returns
RETURN_CODE: Return codes listed as typedef enum in IDTCommon:RETURN_CODE. Values can be
parsed with device_getResponseCodeString:
13.7.2.71 - (RETURN_CODE) icc_getICCReaderStatus: (ICCReaderStatus ∗∗) readerStatus
Get Reader Status
Returns the reader status
#80152504-001 IDTech iOS SDK Guide for NEO2