IFM SI 5000 User Manual

ifm efector inc.
TEL: 800-441-8246 • FAX: 800-329-0436
www.ifmefector.com
3/08
Lit. No.: B10308
SI 5000, SI 5001, SI 5010,
SI5011, SI 5006
Visual Indicators and Controls
Green LEDs indicate current flow
Orange LED indicates setpoint, output closed
Red LED indicates setpoint outpoint open
LED 9 flashing indicates current flow is above
the taught flow range
LED 0 flashing indicates current flow is much below
the taught flow range
Pushbuttons for automatic / manual setting
A short circuit is indicated when the display alternately
changes between all red LEDs and the current flow indication.
If no LEDs are lit, check supply voltage (must be >19 V).
SI5000 card 3/3/08 3:36 PM Page 1

IFM SI 5000 Specifications

General

Output circuit	PNP
Short-circuit protection	yes
Overload protection	yes
Inputs/outputs	Digital
Connection type	M12

Summary

Visual Indicators and Controls

LED Status and Flow Indication

Green LEDs show flow, Orange for setpoint/output closed, Red for setpoint/output open.

Flow Range Deviation Alerts

LED 9 flashing indicates flow above range; LED 0 flashing indicates flow below range.

Control Pushbuttons and Error Signals

Pushbuttons adjust settings; short circuits show alternating LEDs; no LEDs means check supply voltage.

Set-up and Scaling the Display

High Flow Adjustment Procedure

Calibrates sensor for maximum flow velocity, indicated by all LEDs lighting up.

Low Flow Adjustment Procedure

Used for media other than water, performed after high flow adjustment.

Setpoint Adjustment Method

Adjusts setpoint for faster response time based on flow direction.

Output Configuration Options

Changes switching output from normally open to normally closed.

Reset to Factory Defaults

Returns all sensor settings to their original factory configuration.