IFM O1D100 series User Manual

Mode/
Enter
Set
PWR mm m inch OUT1 OUT2
Output LED’s
Setting of the parameters
Mode: Selecting the mode
Enter: Acknowledging the setting
4 digit numeric display
Programming Mode
Press until desired menu item is
displayed. (See distance
sensor menu items)
Press to display the current setting.
To change the setting, press and hold the set button
for 5 seconds until the flashing value is continuously
incremented. After this time, the value may be increased
continuously (by holding down the set button) or incre-
mented (by pressing and releasing the button repeatedly)
until the desired value is reached.
Press once to enter desired value.
The desired value is set. If no button is pressed for 15
seconds, the sensor returns to the operating mode.
Repeat these steps to set other values as required.
1
2
3
4
5
6
Display
O1D100 Series
Distance Sensor
Display Unit LED’s

IFM O1D100 series Specifications

General

Manufacturer	IFM
Current consumption	< 100 mA
Housing material	Plastic
Protection	IP 67
Series	O1D100

Summary

Display Overview

Display Elements

Details the status LEDs (PWR, OUT1, OUT2) and the 4-digit numeric display for sensor information.

Parameter Setting Controls

Explains the function of the Mode/Enter and Set buttons for parameter selection and acknowledgment.

Programming Sensor Settings

Configuration Procedure Steps

Step-by-step guide on how to navigate and modify sensor settings using the programming mode.

Sensor Menu Items

Lists available menu items for configuring output settings, hysteresis modes, and analog outputs.

Enhanced Function Options

Details advanced configuration options including delays, display settings, units, and reset functions.

Technical Specifications and Application Data

Presents technical specifications for measuring range, repeatability, accuracy, and background suppression.