iGenix IG9901 - Trouble Shooting Guide

14
Problem Solution
The unit will not switch on • Check Trip Switch / Fuse
• Wait for 3 minutes and start again, protective device may
be preventing unit from working
• Check if the plug is connected to mains socket correctly
• Check batteries in the remote control
Runs for a short while and then
switches off
Runs without cooling in Air
Conditioning mode
• If the door or window is open
• If there is another appliance creating heat in the same room
• Check if the air lter is dirty – if so, clean
• Check if air outlets or inlets are blocked
• The set temperature is too high
TROUBLE SHOOTING GUIDE
If you experience difculties with the appliance, please check the suggestions below before contacting
customer services:
• If the set temperature is close to room temperature,
the unit will automatically switch off, you can lower the set
temperature to restart
• Check if air outlet is blocked, if so remove obstacle
• Check if Timer function has been activated
Water is leaking from unit when
moving
• If the door or window is open
• If there is another appliance creating heat in the same room
• Check if the air lter is dirty – if so, clean
• Check if air outlets or inlets are blocked
• The set temperature is too high
Water is leaking from unit when
moving
• Drain the water tank – refer to Water Drainage on Page 12
• Ensure rubber caps are securely tted to drainage points
• Ensure unit is located on a at and even surface
Error Code: E4 shown on display panel
• Drain the water tank – refer to Water Drainage on Page 12
Error Code: E2 shown on display panel
• Technical Fault – contact Customer Services and
provide error code
Error Code: E3 shown on display panel • Technical Fault – contact Customer Services and provide
error code