11
Adjust Fan Speed
• Press the “Fan” button to select the desired fan speed shown below:
Turning Off
• Press the “On/Off” button to switch off the appliance
Modes - Explained
Auto Mode: The appliance will automatically adjust the functions by either selecting the Cooling or
Fan mode, based on the following principles
• When the room temperature is ≥ 24°C, Cooling mode is selected
• When the room temperature is < 24°C, Fan mode is selected
Dehum. Mode: The fan will operate at low speed (Fan Speed cannot be adjusted in Dehum. Mode)
and then the compressor will be activated. In dehumidifying mode, the appliance will run through a
repeated cycle sequence of:
• 8 minutes both compressor and fan operation
• 6 minutes fan only operation
The appliance adopts a constant temperature, which cannot be manually adjusted
Note: To turn off the Dehumidifying function you can either select a different mode or press the on/off
button.
Cooling Mode: Self Evaporating Air Conditioning mode activated
• When the ambient room temperature is higher than the desired room temperature, the
compressor will operate
• When the ambient room temperature is lower than the desired room temperature, the compressor
will stop and the fan will operate at the selected speed
Fan Mode:
• The fan will operate at the desired speed, the compressor will not run in this mode
Note: Temperature cannot be adjusted in Fan Mode
Heat Mode:
• When the room temperature is higher than the set temperature, the heating function will
automatically stop
• When the room temperature is lower than set temperature, the heating function will start
Additional Functions
Timer: The timer can be set between 1 to 24 hours by increments of 1 hour; to either turn off or on
the appliance.
• To set Automatic time off (whilst unit is running). Press the “Timer” button and then press the
“ ” or “ ” buttons
• To Set Automatic time on (whilst unit is in standby). Press the “Timer” button and then press
the “ ” or “ ” buttons
Oscillation Function
• Press the “OSCIL” button to select the horizontal louvers to automatically move up and down
• Press the “OSCIL” button again to switch off this function
To Next Page
Loading...
