10
Turning Off
• Press the “POWER” button to switch off the appliance
Modes - Explained:
Auto Mode: The appliance will automatically adjust the functions by either selecting the Cooling or
Fan mode, based on the following principles:
• When the room temperature is ≥ 24°C, Cooling mode is selected
• When the room temperature is < 24°C, Fan mode is selected
Dehum. Mode: The fan will operate at low speed (Fan Speed cannot be adjusted in Dehum. Mode)
and then the compressor will be activated. In dehumidifying mode, the appliance will run through a
repeated cycle sequence of:
• 8 minutes both compressor and fan operation
• 6 minutes fan only operation
The appliance adopts a constant temperature, which cannot be manually adjusted.
Note: To turn off the Dehumidifying function you can either select a different mode or press the on/off
button.
Cooling Mode: Self Evaporating Air Conditioning mode activated:
• When the ambient room temperature is higher than the desired room temperature, the compressor
will operate.
• When the ambient room temperature is lower than the desired room temperature, the compressor
will stop and the fan will operate at the selected speed.
Fan Mode:
• The fan will operate at the desired speed.
• (The compressor will not run in this mode)
Note: Temperature cannot be adjusted in Fan Mode
Additional Functions
Timer: The timer can be set between 1 to 24 hours by increments of 1 hour; turning the appliance
either on or off.
• To set Automatic time off (whilst unit is running). Press the “Timer” button and then press
the “ ” or “ ” buttons
• To Set Automatic time on (whilst unit is in standby). Press the “Timer” button and then press
the “ ” or “ ” buttons
Sleep Mode: This operation can only be selected when in Cooling Mode.
• Press the “Sleep” button when in cool mode, the fan will automatically turn down to low fan speed.
The appliance will then operate the following sequence:
• The set temperature will increase by 1°C after 1 hour, then increase by 2°C after 2 hours.
After 6 hours the appliance will automatically switch off.
Adjust Fan Speed
• Press the “Fan” button to select the desired fan speed shown below:
Oscillation Function
• Press the “OSCIL” button to select the horizontal louvres to automatically move up and down
• Press the “OSCIL” button again to switch off this function
To Next Page
