3 – 3
MAINTENANCE
3-2 RECOMMENDED LUBRICANT TABLE
REFILL
CHANGE LUBRICANT
LOCATIONS CAPACITIES
INTERVALS
USE
VISCOSITIES
(APPROXIMATE)
Cold Regions
API, Class CD
SAE20
Diesel Engine General
API, Class CD
SAE30
Tropical
API, Class CD
Regions SAE40
Ambient Wear Proof
Temperature Hydraulic Fuluid
– 5 ºC ISO – VG 46
Ambient Wear Proof
Temperature Hydraulic Fuluid
Below – 5 ºC ISO – VG 32
Track Rollers
0.025 liter Upon
–
(Each) occasion
Front Idlers
0.07 liter Upon
–
(Each) occasion
Travel Drives
0.33 liter
1000Hrs. –
API, Class CD
(Each) SAE30
Lubricate Swing Bearing,
–
EP2 Lithium
the Fitting Attachment pins, etc. Grease
Note:
1. Oils in the hydraulic fluid columns marked with *should be use above 0 ºC.
2. If the oil becomes dirty or deterioration of the oil’s properties are excessive, replace more
frequently than described above.
3. Disassemble the track roller and upper roller when replacing the oil in them.
Max. 250 Hrs.
3.8 liter
Initial oil
Min. change
2.1 liter 50 hours
Total 1000 Hrs.
Amount
Hydraulic 23 liter (500 Hrs.
Oil when
Tank Capacity breaker
19 liter used)
API, GL
–
4
ISO
–
VG 320
(SAE 90)
Gear Oil
To Next Page
Loading...
