Setting the Time
1. Press and hold the Time Set/Sleep Button. “DST ON” will flash in the bottom of the display and a beep will sound. DST ON indicates
the unit is in automatic Daylight Saving Time adjust mode and will automatically adjust the time at the start and end of Daylight Saving
Time in March and November. Press the – or + Button to set unit to “DST OFF” if you are in a location that does not observe Daylight
Saving Time.
2. Press
the Time Set/Sleep Button. The year will flash. Press the – or + Button to set the correct year
.
3. Press
the Time Set/Sleep Button again. The date will flash. Press the – or + Button to set the correct date (press and hold for rapid
setting).
4. Press
the Time Set/Sleep Button again. “CLOCK” will appear and the time will flash. Press the – or + Button to set the correct time
(press and hold for rapid setting). Remember to set the correct
AM or PM time. The AM and PM Indicators are located to the left of the
time digits.
TIP: Press either the or Button when display is flashing during clock setting to toggle the display between 24 hour (military) and 12
hour (standard) display mode. The AM/PM indicators will not appear when display is in 24 hour mode.
5. Press
the Time Set/Sleep Button again (or no button press within 10 seconds) to exit the clock setting mode. 2 beeps will confirm
clock setting is complete.
Setting the Alarms
This unit has a dual alarm system so you can set two separate alarms to different alarm times and sources.
Setting the Alarms
Note: Alarm 1 and Alarm 2 are set the same way; Alarm Button below means the button ( or ) for whichever alarm you are setting.
1. Press and hold the or Button until the alarm icon flashes, the alarm time flashes on the lower part of the display and a beep
sounds. Press and release the – or + Button to set the alarm time (press and hold for faster setting). Remember to set the correct AM
or PM time.
2. Press and release the Alarm Button again to confirm the set alarm time. The current wake schedule will flash. Press and release the –
or + Button as needed to select “7DAYS” (alarm sounds every day), “5 DAYS” (alarm sounds on week days or “2 DAYS” (alarm
sounds only on weekend).
3. Press and release the Alarm Button again to confirm the set alarm schedule. The wake to icon will light and the current alarm source
will flash. Press the – or + Button as needed to select to set the alarm wake-to source: FM radio or Tone.
To wake to FM radio: The default wake to source is the current FM radio station. Press and release the – or + Button to set a
different station (press and hold to scan to the next clear station). To wake to a preset station, press the Presets
Button to cycle to the desired preset (see page 4 for details on setting presets).
4. Press and release the Alarm Button again, then press and release the – or + Button to adjust the alarm volume. Note that alarm
volume is stored separately from standard volume.
5. Press and release the Alarm Button again, then press and release the – or + Button to set the color LED wake cycle: Dawn
(amber fade leading up to alarm time), Flash (flashing red while alarm sounds), Glow (glowing color sequence while alarm sounds) or
None (no wakeup LED effect).
6. Press and release the Alarm Button again (or no button within 10 seconds) to exit the alarm setting mode. 2 beeps will confirm alarm
setting is complete. The alarm will be armed once set and the corresponding alarm icon will light up. The lower part of the display will
show the earliest set alarm time.
3
To Next Page
Loading...
