IHP.us.com
900861-00NC
28
LIGHTING INSTRUCTIONS
READ ALL WARNING AND SAFETY INFORMATION ABOVE BE-
FORE ATTEMPTING TO LIGHT FIREPLACE
1. Turn ON main gas supply and check all fittings and connections
for leaks with a soap and water solution.
HOW TO TURN ON
2. Push the “I” on the ON/OFF switch to turn ON (System will take
approximately 7-10 seconds before ignition after the gas line
Figure 40 - Control panel
WARNING: Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of control system and any
gas control, that has been under water.
CAUTION: Children and adults should be alerted to the hazards
on high surface temperatures and should stay away to avoid
burns or clothing ignition. Young children should be carefully su-
pervised when they are in the area of the appliance.
SAFETY WARNINGS
1. Never leave the fireplace unattended during operation.
2. Clothing or other flammable materials should not be hung
from the appliance or placed on or near the appliance.
3. Any guard or other protective device removed for servicing
the appliance must be replaced prior to operating the appli-
ance.
4. Installation and repair should be done by a qualified service
person. The appliance should be inspected before use and at
least annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative the
control compartment, burners and circulating air passage-
ways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the ap-
pliance.
6. Temporary storage of this appliance indoors is permissible
only if it has been disconnected from its fuel supply (Natural
or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause severe
burns if contacted.
2. Do not burn any solid fuels in this appliance.
3. These appliances are not designed or intended to be used for
cooking. Do not barbecue, heat food, or roast marshmallows
in this appliance. Doing so could damage the appliance and
cause injury.
4. These appliances are not designed or intended to be used for
cooking. Do not barbecue, heat food, or roast marshmallows
in this appliance. Doing so could damage the appliance and
cause injury.
is purged). During this time, an “Ignition In-Process” beeping
pattern will take place. (e.g. one short beep, pause, three short
beeps, pause; repeated until ignition occurs). NOTE: Beeping
pattern may be difficult to hear outdoors.
3. The main flame ignites (defaults) in the HIGH position. Press
the “I” on the LOW/HIGH button to adjust to the LOW setting.
4. A continuous pilot flame can be turned ON or OFF with the con-
tinuous pilot button.
5. Push the “I” on the LED ON/OFF switch. LED’s will turn ON. Ad-
just the intensity of the lighting by turning the knobs clockwise
on each dimmer knob. There is infinite color combina-
tions by adjusting the dimmer knobs to personal taste.
HOW TO TURN OFF
1. To turn OFF the fireplace press the “O” position on the ON/OFF
switch. This will turn OFF the fireplace. NOTE: Fireplace must
be OFF for 5-minutes before relighting.
To turn OFF the LED lights in the fireplace press the “O” position
on the LED ON/OFF switch. This will turn OFF the LED lights.
The LED lights are independent of the fireplace and can be used
when the fireplace is not in operation.
OPERATION
RGB DIMMER
Mounting plate under switch cover
LED
ON/OFF
ON/OFF
LOW
HIGH
LEARN
CONT.
PILOT
5-5/8”
(143mm)
5-5/8”
(143mm)
To Next Page
