IHP BarcelonaLights36ZEN - Gas Conversion Instructions

900861-00NC
33
IHP.us.com
GAS CONVERSION INSTRUCTIONS
Step 1. Turn OFF the gas supply to the outdoor fireplace and discon-
nect any electrical power.
Step 2. Remove the burner pan from the fireplace to enable conver-
sion access. See installation manual if necessary.
Step 3. Disconnect the flex line at the main burner orifice. Then re-
move the orifice and flared fitting from the orifice. Re-tape the flared
fitting with the new OAS-LP orifice per Table 9. Ensure to use gas
rated Teflon tape around the threads or pipe compound. Check for
leaks after conversion is complete.
Step 4. Locate the gas regulator on the opposite side of the valve
box. Using a regular size flat bladed screwdriver to remove the alu-
minum cap and washer from the regulator. See Figure 42.
NOTE: The plastic stem has a marking on it with an arrow. Look
carefully on the stem, it may be difficult to read.
The gas type is determined with the arrow pointing at the aluminum
cap as seen in Figures 44 and 45.
Step 5. On the underneath side of the aluminum cap is a plastic
stem. Using a 6mm wrench remove the stem, unscrew the stem
(counter-clockwise
), turn it over and install the opposite end
back into the cap. See Figure 44.
NATURAL GAS TO PROPANE GAS CONVERSION
Continued
Model Main Burner Orifice Low Rate Set Screw
LPK1 (36” Fireplace) OAS-LP52 ECO-LSS-52
LPK2 (48” Fireplace) OAS-LP48 ECO-LSS-46
LPK3 (60” Fireplace) OAS-LP44 ECO-LSS-42
LPK4 (72” Fireplace) OAS-LP42 ECO-LSS-35
Table 9 - Reference Information
Figure 42 - Changing Main Burner Orifice
Regulator
Valve Box
Pilot Box
Disconnect
Flex Line
Orifice
Figure 43 - Regulator cap location
Regulator
Aluminum Cap
Figure 44 - Regulator stem shown in NG setting
NG
Regulator
Plastic Stem
LP
Figure 45 - Regulator stem shown in LP setting
Regulator
Plastic Stem