IIWEY S2 - REMINDER

REMINDER
(Please read the manual carefully before use).
After-sale service team e-mail:support@iiwey.com
32GB SD card is installed in the front camera, please check the
card slot.
Please connect to power and charge the S2 dash cam for 5
minutes at least before use. The dash cam will turn off within5
seconds when you turn off the engine, it is default setting to
save power for parking monitoring and emergency video
backup.
After stop recording each time, please wait for 2-3 seconds until
the dash cam saves all the videos before performing other
operations. High frequency operation may cause the screen to
freeze, if you encounter this problem, you can reset the camera
(tap the rest hole). When the dash cam is recording, we can’t
operate the dash cam through the touchscreen, useless we
press the OK button to stop recording first, then we can use the
touchscreen to operate.
The dash cam comes with Reversing Aid function. If you need
this function, please connect the Red Wire of the rear camera
to the live wire of the reverse lamp. If you don't need this
function, please ignore the red wire and hide it, just connect the
rear camera to the main camera, these two cameras will work
well without any problem. Since the reversing lamps are
different for each car, we cannot provide precise installation
guidance for the red wire. It is recommended to consult a
professional if you need to install the red wire.
The dash cam has GPS function. After installing the GPS, you
needn’t to set the time manually. You just need to set the time
zone according to your location and choose the summer time
(If in summer). Then the time will rectify itself.
https://youtu.be/rUYGSv1FXQk
The video Guide shows How to install the S1 dash cam, S2 is the
upgraded version of S1 model. It gets a great improvement in chip,
image sensor and system. But the installation method of the two
models is the same, the only difference is that we choose a different
rear-view camera for S2 kit to satisfy more people demand. The rear-
view camera of S2 is waterproof, you can refer to the video guide to
install it in the car, you can also install it outside the car. The rear
camera installed outside has a better video performance than
installed inside the car.
1. Install a Micro SD card. 32GB-256GB
Reminder: We recommend a Class 10 and above U3 MicroSD card,
4
do not use U1 class. Because S2 model with a high configuration,
SD card needs high read and write speed to work well. U1 can’t meet
this demand very well. If you use a U1 memory card, the camera will
prompt ‘card slow’ after a period of use (choose the SD card like
below). Please format the SD card on the dash cam and computer
before the first use.
1) Format the memory card on your S2 dash camera.
[Carefully insert the memory card into the camera’s card slot until it
clicks. To remove the card, power off the camera first, then push the
card into the slot until it clicks again.]
Insert the memory card and connect to power, if the dash cam start
recording automatically please click the Start/Stop Recording icon
(the icon in the lower left corner of the screen) to stop recording first,
then click the MENU Setting icon (Icon in the lower right corner of
the screen) to enter the MENU setting page, swipe your finger UP
on the screen to find the Format function.
If you meet ‘Card error’ ‘Memory error’ after you format it on the
camera, please format the memory card again on the computer.
2) Format MicroSD card on the computer
If you use a 128GB or 256GB memory card and meet a 'memory
error', this step is very necessary.
Format on the Mac. Please format it to ‘exFAT’
Format on the Windows. Please format it to ‘exFAT’
Reminder: Set the ‘Allocation unit size’ to 32KB or 64KB
Reminder:
1. Ideally, the MicroSD card should be formatted every 2 weeks to