16
Err 09 Pump off
Heating off
Device internal temperature is too
high
- Check the ambient temperature and let the de-
vice cool down
Err 10 Pump off
Heating off
PC communication failure
- Check communication cable
Err 11 Pump off
Heating off
Temperature difference between
control sensor and safety sensor is
too much
- Check safety temperature circuit and bath fluid
Err 12 Pump off
Heating off
Safety temperature alarm
- Check the bath temperature measurement
Err 13 Pump off
Heating off
Heater switched off by safety
circuit
- Check safety temperature set value, fluid level
Err 14 Pump off
Heating off
Fan error - Check the fan and clean the grids at the rear side
If the actions described fails to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the service department;
- Send the device for repair, including a short description of the fault.
Accessories
•
Tubing, hoses, adapters and couplings:
LT 5.20 Metal hose (isolated M16 x 1)
LT 5.21 PTFE hose (isolated M16 x 1)
H.PVC.8 PVC hose (nominal width 8)
H.PVC.12 PVC hose (nominal width 12)
H.SI.8 Silicone hose (nominal width 8)
H.SI.12 Silicone hose (nominal width 12)
•
Tubing Insulations:
ISO. 8 Insulation (8 mm)
ISO.12 Insulation (12 mm)
•
Bath vessels:
IB eco 8 Plastic bath (8 litres)
IB eco 18 Plastic bath (18 litres)
IB pro 9 Stainless steel bath (9 litres)
IB pro 12 Stainless steel bath (12 litres)
IB pro 20 Stainless steel bath (20 litres)
•
Bridges and Covers:
BS.ICC Small bridge (for IB eco 8, IB pro 9)
BL.ICC Large bridge (for IB eco 18, IB pro 12,
IB pro 20)
CS.ICC Samll cover (for IB eco 8, IB pro 9)
CM.ICC Medium cover (for IB pro 12)
CL.ICC Large cover (for IB eco 18, IB pro 20)
•
Additional accessories:
PCS.ICC Pump set
PC 1.1 Cable (RS 232)
USB 2.0 cabel A - Micro B
Labworldsoft
®
See more accessories on www.ika.com.
To Next Page
Loading...
